Digi X2 Bedienungsanleitung PDF herunterladen (Seite 158)

Configuration through the web interface

158

Advanced remote management settings

The default settings for remote management usually work for most situations. These

Advanced settings are used in advanced situations. They are used to configure the idle

timeout for the connection between the Digi device and the Connectware Manager server,

and the keep-alive settings of the various interfaces (TCP and HTTP for mobile and

Ethernet network connections). These settings should only be changed when the defaults

do not properly work.

 Connection Settings: These settings configure the idle timeout for the

connection between the Digi device and the Connectware Manager server.

– Disconnect when Connectware Management is idle: Enables or disables the

idle timeout for the connection. If enabled, the connection will be dropped, or

ended, after the amount of time specified in the Idle Timeout setting.

– Idle Timeout: The amount of time to wait before timing out the connection.

 Mobile Settings:

Ethernet Settings: These settings apply to client-initiated management

connections over the mobile/cellular and Ethernet networks.

– Connectware Management Protocol Keep-Alive Settings: These settings

control how often keep-alive packets are sent over the client-initiated

connection to the Connectware Manager server, and whether the device waits

before dropping the connection.

Receive Interval:

The number of seconds to wait for a keep-alive

message from the Connectware Manager server before assuming

the connection is lost.

Transmit Interval: The number of seconds to wait between sending keep-

alive messages. (

Assume connection is lost after n timeouts: How many timeouts occur

before the Digi device assumes the connection to the Connectware

Manager server is lost and drops the connection.

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 253 254

Keine Kommentare

Digi X2 Bedienungsanleitung Seite 158