Digi M10 Technical overview and Installationsanleitung Seite 22
- Seite / 82
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Chapter 3: Assembling Legs 17
Attaching the End Shelves
To attach the End Shelves:
Using four fasteners and washers per side, attach the Left and Right End Shelves to the Legs as shown in Figure 6.
Leveling the Leg Frame
To level the back legs:
Use the 13 mm open end wrench (included with the Legs) and adjust the back leveling feet (see Figure 7). When looking down
at the feet from above, turn the wrench clockwise to raise or counterclockwise to lower.
Fasteners, Washers, and Tools for End Shelves
Fastener
M5x15
Washer
M5
Tool
M4 Hex
Figure 6. Attaching the Left End Shelf (Right End Shelf shown attached)
Figure 7. Back Leg Leveler
(Not to scale)
- S6 Installation Guide 1
- Legal Notices 2
- Contents 3
- S6 Installation Guideiv 4
- Part I: Introduction 5
- Chapter 1: Introduction 6
- Overview of Installation 7
- What’s Included 7
- Activation and Registration 8
- About This Guide 9
- About www.avid.com 9
- Master Section Modules 10
- Channel Modules 11
- Knob Module 12
- Display Module 12
- Module Layout 13
- S6 Installation Guide10 15
- Part II: Frames 16
- Chapter 3: Assembling Legs 18
- Attaching the Back Beam 19
- Attaching the Front Beam 20
- (Not to scale) 21
- Attaching the End Shelves 22
- Leveling the Leg Frame 22
- How to Proceed 23
- Before You Begin 24
- Frame Chassis Kit Components 25
- Assembling the Chassis 26
- S6 Installation Guide22 27
- M3x6 SEMS (7760-30025-01) 28
- #1 Phillips 28
- Important 29
- Attaching the Back Feet 30
- Leveling the Chassis 32
- Attaching the Bolster 33
- M5x12 FHCS 34
- M5x8 SHCS (7760-30593-00) 35
- Installing Side Covers 36
- Part III: Modules 38
- Overview 40
- Installing the Power Strip 41
- Ethernet Switch” on page 40 43
- 6-Chassis Systems 44
- 7-Chassis Systems 44
- 9-Chassis Systems 44
- S6 Installation Guide40 45
- Installing PSUs 46
- To connect power to PSUs: 47
- 12 3 4 512 3 4 5 49
- 12 3 4 5 49
- 12 3 4 512 3 4 5 12 3 4 5 50
- 12 3 4 5 12 3 4 512 3 4 5 51
- 7- and 9-Chassis Systems 52
- S6 Installation Guide48 53
- To attach the Side Covers: 55
- M4x14 FHPH 56
- #2 Phillips 56
- Chapter 6: Installing Modules 58
- Installing Modules 59
- S6 Installation Guide56 61
- Automation 62
- Installing the Master Module 63
- Setting the Touchscreen Angle 64
- Installing Fill Panels 65
- Installing Display Modules 65
- Gigabit 66
- Ethernet RJ45 66
- S6 Installation Guide62 67
- Chapter 7: How to Proceed 68
- Installing Compression Panels 69
- Installing T Strips 70
- Figure 40. Upper Rear Panel 71
- Updating S6 System Software 72
- Configuring the S6 System 73
- Part IV: Appendices 74
- Removing Modules 76
- Disassembling a Frame 77
- Appendix B: Compliance 78
- Australian Compliance 79
- Canadian Compliance 79
- CE Compliance 79
- Safety Compliance 80
- Korea Class B EMC Compliance 80
- S6 Installation Guide76 81
- Technical Support (USA) 82
- Product Information 82
Verwandte Produkte und Handbücher für Vernetzung Digi M10 Technical overview and
(4 Seiten)Black & Decker FP5050SC Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Kleine Küchengeräte Black & Decker FP5050SC.
Wir stellen 1 PDF-Handbücher Black & Decker FP5050SC zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Gebrauchs- und Pflegehandbuch
Kommentare zu diesen Handbüchern