Digi M10 Technical overview and Installationsanleitung Seite 62

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 82
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 61
Chapter 6: Installing Modules 57
Installing Master Section Modules
Installing the Automation Module is nearly identical to installing a Fader Module.
Installing the Automation Module
To install the Automation Modules:
1 If you haven’t already done so, unpack the Automation Module and Master Module.
2 Hold the Automation module above its chassis and do the following:
Connect the longest 2-pin Molex power cable to the DC input on the side of the module.
Connect the longest Ethernet cable to the Ethernet port on the side of the module.
3 Install the connected Automation Module into the first (front-most) slot of the chassis. Make sure the module sits completely
into the frame and not on any cables
Automation Module in slot 1 of the chassis (switch and PSUs not shown)
Slot 1
Automation
Module
Seitenansicht 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 81 82

Kommentare zu diesen Handbüchern

Keine Kommentare