Digi ConnectPort Network Device Betriebsanweisung PDF herunterladen (Seite 125)

125

Backup/restore device configuration from a TFTP or BOOTP Server from the command line

From the command-line interface, the ―backup‖ command backs up the device configuration to a

TFTP or BOOTP server located on the network or a storage device in the ConnectPort LTS device,

or restores the configuration.

backup [to=serveripaddress[:filename]|

[to={sd|usb|nfs|samba|userspace}[:filename]]

[from=serveripaddress[:filename] print]|

[from={sd|usb|nfs|samba|userspace}[:filename]]

Where:

to=serveripaddress[:filename]

The IP address of the TFTP server to which the configuration will be saved, and

the filename that the configuration will be saved as. If a filename is not specified,

the default filename of config.rci is used.

to=(sd|usb|nfs|samba|userspace)[:filename]

The location of the storage device to which the configuration will be saved, and

the filename that the configuration will be saved as. If a filename is not specified,

the default filename of config.rci is used.

from=serveripaddress[:filename]

The IP address of the TFTP server and the filename from which the configuration

will be restored. If a filename is not specified, the default filename of config.rci is

assumed. In ConnectPort LTS, the system will be rebooted after restoring

configuration.

from=(sd|usb|nfs|samba|userspace)[:filename]

The location of the storage device and the filename from which the configuration

will be restored. If a filename is not specified, the default filename of config.rci is

used.

Prints out the current device configuration.

Example #> backup from=10.0.0.1:config.rci

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 148 149

Keine Kommentare

Digi ConnectPort Network Device Betriebsanweisung Seite 125