Digi ConnectPort Network Device Betriebsanweisung PDF herunterladen (Seite 69)

TCP settings

The TCP Settings are displayed only when the current serial port is configured with the TCP

Sockets or the Custom Profile. The settings are as follows:

 Send Socket ID: Include an optional identifier string with the data sent over the network. The

Socket ID can be 1 to 256 ASCII characters. To enter non-printable characters, use these key

sequences:

Character

Key Sequence

backspace

formfeed

tab

new line

return

backlash

hexadecimal values

\xhh

 Send data only under any of the following conditions: Enable if it is required to set

conditions on whether the ConnectPort LTS product sends the data read from the serial port to

the TCP destination. Conditions include:

Send when data is present on the serial line: Send the data to the network destinations

when a specific string of characters is detected in the serial data. Enter the string 1 to 4

characters in the Match String field. To enter non-printable characters, use these key

sequences:

Character

Key Sequence

hexadecimal values

\xhh

tab

linefeed

backspace

Strip match string before sending: Match string before sending to strip the string from

the data before it is sent to the destination.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 148 149

Keine Kommentare

Digi ConnectPort Network Device Betriebsanweisung Seite 69