Digi Digi One EM Installationsanleitung PDF herunterladen (Seite 103)

set pmodem

Chapter 2 Command Descriptions 103

telnet

Used to enable or disable Telnet processing on the incoming and

outgoing modem-emulation connections.

Enables Telnet processing.

off

Disables Telnet processing.

The default is “off.”

Example set pmodem port=1 state=on

See also • "revert" on page 39

• Chapter 3, "Modem Emulation Commands" for descriptions of Digi-

specific commands for modem-emulation configurations.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 167 168

Digi Connect 1
Contents 3 3
4 Contents 4
Introduction 5
Feature/Task Commands 6
Basic Command Information 9
Access the Command Line 11
Configure an IP Address 11
Introduction 12
Command Descriptions 13
Reboot the device server 15
Close the current session 17
Close all active sessions 17
Device statistics 26
Statistic Description 27
IP statistics 28
Display ICMP statistics 32
Change Telnet options 34
Display Telnet options 34
Turn on binary mode 34
Add line feed characters 34
Display operating options 34
Specify a simple ping 36
Reconnect to port 1 38
Reconnect to session 1 38
[ip_address] 42
[subnmask[1-32]=mask] 44
Set access control settings 45
Set alarms in GPIO mode 46
Set alarms in match mode 46
Set an alarm to “on” state 50
Set alarm mode to GPIO mode 50
Configure autoconnect 51
Display autoconnect settings 51
Configure port buffering 55
Configure buffers 56
Set device security settings 59
Set forwarding settings 62
Display forwarding settings 62
Enable IP forwarding 62
Configure GPIO pins 63
Add a group 65
Remove a group 65
Display the current host name 68
Updating Global Settings 69
Adding/Updating Custom Menus 69
[lkaupdateenabled={on 74
"revert" on page 39 76
Set the device id 77
Commands without permissions 86
Syntax Set permissions 87
Set group permissions 101
Set user permissions 101
Configure modem emulation 102
Display PPP outbound settings 104
Turn on off RCI serial mode 113
Enable or disable RTS toggle 114
Set SNMP settings 120
Display current SNMP settings 120
Configure terminal settings 126
Configuring Wireless Settings 136
Inner and outer protocols 138
Configure wireless settings 139
Display wireless settings 139
#> set wlan wepmode=128bit 143
Command Descriptions 146
Modem Emulation Commands 151
User Scenario - Diagram A 152
User Scenario - Diagram B 153
RING and the 154
S-Register Definitions 159
Modem Emulation Commands 160
Result Codes 161
168 Index 168
Xon/Xoff 117 168

Kommentare zu diesen Handbüchern

Keine Kommentare

Digi Digi One EM Installationsanleitung Seite 103

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Digi Digi One EM