Digi CM Betriebsanweisung PDF herunterladen (Seite 128)

Installing Power Controller

128 Chapter 14

The following illustration shows a Sun server configured through a serial port

connection on the Digi CM 32.

Installing Power Controller

To connect the Digi RPM power controller to the Digi CM unit use the straight-

thru cable provided with the Digi RPM unit. Plug one side into the “Console”

port of the Digi RPM unit and the other into any port of the Digi CM unit. If you

plan to connect multiple power controllers, set up all of them as described

before proceeding. For details on how to configure the Digi RPM unit for

cascading refer to "Cascading Multiple Digi RPM Units" on page 136.

If you are using any other manufacturer of power controllers, please refer to

"About Serial Port Cabling" on page 185 for more information.

Before proceeding, plug the power controller into an appropriate power source

and turn it on.

Note: The DIP switches on the Digi RPM unit are used for cascading. Make sure that

the dip switches of the first unit are set to off. For more information about

cascading refer to "Cascading Multiple Digi RPM Units" on page 136.

Configuring Power Controller

Only system administrators can add a power controller although authorized

users may reconfigure outlets or serial ports.

Configure the Serial Port Parameters to Match the Power Controller

1. Log in to the Digi CM unit (username root, password dbps).

2. Click Serial port > Configuration.

3. Select the port number of the serial port you want to connect to the power

controller.

4. Select the

Serial port parameters:

Baud rate 9600

Data bits 8

Parity None

Stop bits 1

Flow control None

DTR behavior High when open

5. Click Save & apply.

6. Continue by adding the power controller.

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 201 202

Keine Kommentare

Digi CM Betriebsanweisung Seite 128