Digi CM Betriebsanweisung PDF herunterladen (Seite 96)

Setup Overview

96 Chapter 10

Setup Overview

Setup for the Digi CM unit SAC support is a three-step process:

1. Set up the Windows Server 2003 for SAC support. To do this, ensure that

the COM port used for console traffic is properly set up. This includes

designating a COM port for console communication and setting the port

speed (baud) appropriately. For further information please refer to Setting

Up the Windows Server 2003 Port below.

2. Cable the console port on the Windows Server 2003 to the Digi CM unit’s

port. See the cabling information in Chapter.

3. Set up the Digi CM unit for SAC support. See "Setting Up the Digi CM Unit

for SAC Support" on page 96.

Setting Up the Windows Server 2003 Port

1. Sign on to the Windows Server 2003 as the administrator.

2. Access the command line.

3. Use the bootcfg command to redirect console traffic to the correct COM

port. The following is the command syntax and an example. See the

Microsoft documentation for additional information on the SAC feature.

Command Syntax

bootcfg /ems on /port com# /id # /baud 115200

where:

• com# is the COM port to which console traffic will be redirected.

• # is the is the number of the boot entry.

• The port speed is set to the recommended rate (although you can use any

rate supported by Windows Server 2003).

Command Example

In this example, console output is redirected to COM 2, the boot entry is

specified as 1, and the port speed set to 115200.

bootcfg /ems on /port com2 /id 1 /baud 115200

Setting Up the Digi CM Unit for SAC Support

To set up a serial port to provide access to the Windows Server 2003 console

port, do the following:

1. Access the web interface.

2. Choose Serial port > Configuration.

3. Choose a port.

4. Choose

Host mode configuration.

The Host mode configuration page appears.

5. Set the Host mode to Console server and the Type of console server to MS

SAC -English (or Japanese) console as shown in the following figure.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 201 202

Keine Kommentare

Digi CM Betriebsanweisung Seite 96