Digi CM Betriebsanweisung PDF herunterladen (Seite 133)

Power Controller

Chapter 14 133

6. Under Everyone uncheck the Access type and click Save to flash.

7. Enter the user that will have access and check the Access type.

Note: Port is access to the port. Monitor is access to sniff. Power is access to the power

management.

8. Click Save to flash. Repeat steps 7 and 8 for additional users.

9. Click Save & apply after all users have been entered.

Note: The screen above shows outlets 1 & 2 control power to the Sun Server configured

on port 1 of the Digi CM unit. Outlets 3 and 4 are not serial devices. Gilligan has

been designated the specific user to control outlet # 3.

Configuring to Restrict Specific Users

To restrict specific users, you must select access for << Everyone>> and add

the restricted user by deselecting his or her access.

1. Log in to the Digi CM unit (username root, password dbps).

2. Click Power Controller > Configuration > Outlets > Select the outlet # to

configure.

3. Select the port to configure to the outlet. If it is a non-serial device select

None.

4. Edit the outlet title. If there is a serial port, the port title will appear and

cannot be edited from this screen.

5. Click Save & apply.

6. Check Everyone and click Save to flash.

7. Enter the username that will NOT have access, uncheck the Access types

that are restricted, and click Add.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 201 202

Keine Kommentare

Digi CM Betriebsanweisung Seite 133